Dataset of Physical and Transport Property Variations Within the Carbonate-Bearing Fault Zones of the Monte Maggio Fault (Central Italy)

Trippetta, Fabio; Carpenter, Brett M; Mollo, Silvio; Scuderi, Marco M.; Scarlato, Piergiorgio; Collettini, Cristiano;

2017-11 || GFZ Data Services

Here we report the raw data of the physical properties of carbonate samples collected along the Monte Maggio normal Fault (MMF), a regional structure (length ~10 km and displacement ~500 m) located within the active system of the Apennines (Italy). In particular, we report results coming from large cores (100 mm in diameter and up to 20 cm long) drilled perpendicular to the fault plane made of Calcare Massiccio (massive limestone) and Bugarone fm (limestone with 8.3 % of clay).



From these large cores, we obtained smaller cores, 38 mm in diameter both parallel and perpendicular to the fault plane, that have been used for experiments. We have divided the rock samples in four categories following the fault architecture. The four structural domains of the fault are:1) the hangingwall (HW) made of Bugarone fm that is still preserved in some portions of the fault, 2) a Cemented Cataclasite (CC) and 3) a Fault Breccia (FB) that characterize the cataclastic damage zones and 4) the correspondent undeformed protolith of the footwall block made of Calcare Massiccio.



Raw data reported here are those used for drawing Figures 5, 6, 8 and 9 of the paper “Physical and transport property variations within carbonate- bearing fault zones: Insights from the Monte Maggio Fault (central Italy)”, http://doi.org/10.1002/ 2017GC007097 by Trippetta et al.



Dataset_Fig05.txt reports P- and S-wave velocities (in km/s) of the described samples at pressure from 0.1 MPa (ambient pressure) up to 100 MPa at ambient temperature in dry conditions and the corresponding Vp/Vs ratio. Experiments have been performed by using the permeameter at the HP-HT Laboratory of experimental Volcanology and Geophysics at INGV (Rome).



Dataset_Fig06.txt reports permeability data (in m^2) on the same type of samples of fig05 for the same range of confining pressure at ambient temperature. Pore pressure values athletes each confining pressure step are indicated in the file. Data have been again acquired with the permeameter.



Dataset_Fig08.txt reports P-wave velocity data (in km/s) vs depth (in m), recorded on the portion that crossed the Calare Massiccio fm of three boreholes drilled in the Apennines: Varoni 1, Monte Civitello 1 and Daniel1. Data have been obtained by digitalizing each pdf file of the boreholes mentioned above, that are available at http://unmig.sviluppoeconomico.gov.it/videpi/videpi.asp. Once digitalized, respect to the original pdf file, velocity data have been simply converted from um/f to km/s.



Dataset_Fig09.txt reports values of the maximum, minimum and average values of Critical fault nucleation length (in m) at each corresponding depth (in m) and applied confining pressure (in MPa). Critical nucleation lengths have been calculated by using the equations described in the text of the Trippetta et al paper and by using the elastic parameters calculated from data reported here. Data on earthquakes-depth distribution of the 2009 L'Aquila sequence can be found on Chiaraluce et al. (2011).



Originally assigned keywords

Corresponding MSL vocabulary keywords

MSL enriched keywords

Originally assigned sub domains
  • rock and melt physics
MSL enriched sub domains
  • rock and melt physics
  • analogue modelling of geologic processes
Source http://dx.doi.org/doi:10.5880/fidgeo.2017.019
Source publisher GFZ Data Services
DOI 10.5880/fidgeo.2017.019
License CC BY 4.0
Authors
  • Trippetta, Fabio
  • 0000-0001-8336-2194
  • Dipartimento di Scienze della Terra, Sapienza Università di Roma
  • Carpenter, Brett M
  • 0000-0002-3451-2528
  • School of Geology and Geophysics, University of Oklahoma, Norman, OK, USA
  • Mollo, Silvio
  • 0000-0002-1448-0282
  • Istituto Nazionale di Geofisica e Vulcanologia, Roma, Italy
  • Scuderi, Marco M.
  • 0000-0001-5232-0792
  • Dipartimento di Scienze della Terra, Sapienza Università di Roma
  • Scarlato, Piergiorgio
  • 0000-0003-1933-0192
  • Istituto Nazionale di Geofisica e Vulcanologia, Roma, Italy
  • Collettini, Cristiano
  • 0000-0002-4828-2516
  • Dipartimento di Scienze della Terra, Sapienza Università di Roma
References
  • Trippetta, F., Carpenter, B. M., Mollo, S., Scuderi, M. M., Scarlato, P., & Collettini, C. (2017). Physical and Transport Property Variations Within Carbonate‐Bearing Fault Zones: Insights From the Monte Maggio Fault (Central Italy). Geochemistry, Geophysics, Geosystems, 18(11), 4027–4042. Portico. https://doi.org/10.1002/2017gc007097
  • 10.1002/2017GC007097
  • IsSupplementTo
  • Chiaraluce, L., Valoroso, L., Piccinini, D., Di Stefano, R., & De Gori, P. (2011). The anatomy of the 2009 L’Aquila normal fault system (central Italy) imaged by high resolution foreshock and aftershock locations. Journal of Geophysical Research, 116(B12). https://doi.org/10.1029/2011jb008352
  • 10.1029/2011JB008352
  • Cites
Contact
  • Trippetta, Fabio
  • Dipartimento di Scienze della Terra, Sapienza Università di Roma
  • fabio.trippetta@uniroma1.it
Citation Trippetta, F., Carpenter, B. M., Mollo, S., Scuderi, M. M., Scarlato, P., & Collettini, C. (2017). Dataset of Physical and Transport Property Variations Within the Carbonate-Bearing Fault Zones of the Monte Maggio Fault (Central Italy) [Data set]. GFZ Data Services. https://doi.org/10.5880/FIDGEO.2017.019
Spatial coordinates
  • eLong 12.952194213867188
  • nLat 42.781543233362996
  • sLat 42.75823057701311
  • wLong 12.927989959716797